Amps wired up, and all channels tested.

The box is in the truck, hopefully for the last time. I have powered it up, and tested each channel through the amps. It is not permanently installed yet, since I may need to move it out at some point. All that is left to do, is to put the screws through the tabs to secure it to the floor, screw down the subwoofers, add the plate over the upper amp, and adjust the amps once the input is installed.

I have converted an MTX logo into a vector format, so that I can cut it out of white vinyl and put it on the top acrylic plate.

The input wires have been mapped out. I put together a project box with RCA connectors, so that I can just use RCA->stereo cables to jumper across to the motherboard.

Next up is to install the drivers seat, so that the truck can be moved if needed, and get to work on the dash and console.